Bio-Rad PDQuest 2-D Analysis Software User Manual
Page 14
•
Remove the camera from the Camera System box and remove the blue protective film
from the front of the camera.
•
Remove the 8 mm lens from the Camera System box.
•
Use the red handled 2 mm hex driver in the accessories box to tighten the 2 mm hex
screw in the silver locking collar of the lens (if it is loose) before mounting it on the camera.
•
Screw the lens into the C-mount fitting on the camera until snug.
•
Install the bandpass filter on the lens using the following steps, even if you are not
installing the Fluorescent Enclosure.
1. The bandpass filter is shipped in the Camera System box 165-7070. It includes a
filter holder, a 620/60 nm bandpass filter, and a 0.9 mm hex wrench.
Fig. 6. Lens and Bandpass filter set.
2. Screw the filter into the filter holder. The threads are very fine, so be careful not to
cross the threads.
Fig. 7. Lens and filter on camera.
11