Bio-Rad PDQuest 2-D Analysis Software - Manual (Page 6)

3
1.5 Caution
It is detrimental to the system to leave the lighting on for more than 10 minutes at a time as it may lead to
permanent damage to sections of the system.
1.6 Moving the Spot Cutter
The System should be moved:
• In the upright position.
• By lifting and carrying from the base.
• By placing down in the upright position on a stable and level surface.
Note: DO NOT move the system by lifting the system up by the camera arm.
1.7 Computer Recommendations
Processor 300 MMX or greater
2.1G Hard Drive or greater
RAM 128 Mb or greater
Screen Resolution 1024 x 768
Communication port 1 serial port is required
Add PCI Interface card (included with spot cutter)
2 Mb Video RAM
Operating system Windows 98, NT, or 2000
1.8 Cutting Excision Sizes
Nominal Tip Size:
1.5 mm internal diameter:
Supplied with spot cutter
1.0 mm internal diameter: Supplied with spot cutter
1.9 Voltage Specifications
Nominal input voltage range 100 V to 240 V (50 Hz/60 Hz)
Power consumption 220 W