Bio-Rad PDQuest 2-D Analysis Software User Manual
Page 22
Advertising
![background image](/manuals/600248/22/background.png)
•
Loosen the camera mount screw on the back of the camera (shown in Fig. 5)
•
Slide the camera to the side (left or right) needed to correctly position the camera.
•
Tighten the screw.
•
Acquire a new image to check the position. Repeat until the camera is correctly
positioned as shown in Figure 15c.
Fig. 15b. Image too far to the right.
Fig. 15c. Image correctly aligned.
19
Advertising
This manual is related to the following products: