Dell PowerEdge R905 - Manual (Page 102)

102
Installing System Components
Figure 3-19. Removing and Installing the Heat Sink
7 Wait 30 seconds for the heat sink to loosen from the processor.
8 Loosen the second heat-sink retention screw.
9 If the heat sink does not separate from the processor, carefully rotate the
heat sink in a clockwise, then counterclockwise, direction until it releases
from the processor. Do not pry the heat sink from the processor.
10 Lift the heat sink off of the processor and set the heat sink upside down.
11 Use a clean lint-free cloth to remove any thermal grease from the surface of
the processor shield.
1 heat sink 2 heat-sink retention screws (2)
2
1