Dell PowerEdge R905 - Manual (Page 120)

120
Installing System Components
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 67.
3 Disconnect the control panel data cable from the control panel board.
See Figure 3-27.
4 If you are replacing the control panel data cable, disconnect the cable from
the system board connector (see Figure 6-1), and unroute the cable from
the cable guides on the chassis.
5 Disconnect the display module cable from the control panel board. See
Figure 3-27.
6 Remove the three Torx screws securing the control panel board to the
system chassis and remove the board.
7 Remove the display module:
a Insert the end of a paper clip into the hole on the right side of the
display module and gently pry the label off.
b Remove the two Torx screws that secure the display module to the
system chassis.
8 Remove the display module from the chassis cutout.