Installing the chassis intrusion switch – Dell PowerEdge R905 User Manual
Page 123
Advertising
Installing System Components
123
Figure 3-28.
Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Connect the intrusion-switch cable to its system board connector. See
Figure 3-28.
2 Insert the switch into the opening in the chassis wall and gently, but firmly,
press in the switch until it is fully seated. See Figure 3-28.
3 Close the system. See "Closing the System" on page 68.
4 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1
intrusion switch
2
intrusion switch cable
1
2
Advertising