Peripheral interposer board, Removing a peripheral interposer board – Dell PowerEdge R905 User Manual
Page 128
128
Installing System Components
c
Slide the retention slots on the backplane over the retention hooks on
the chassis.
d
Slide the backplane downward until the blue retention pin snaps into
place.
2 Connect the SAS, interface, and power cables to the SAS backplane.
3 Connect the control-panel cable to the front of the SAS backplane.
4 Install the SAS hard drives in their original locations. See "Hard Drives" on
5 Install the optical drive carrier.
Slide the drive carrier into its drive bay and press in the release latch. See
Figure 3-19.
6 Replace the cooling shroud assembly. See "Replacing the Cooling Shroud
7 Replace the PEM. See "Replacing the PEM or PEM Shell" on page 78.
8 Close the system. See "Closing the System" on page 68.
9 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Peripheral Interposer Board
Removing a Peripheral Interposer Board
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 67.
3 Remove the PEM. See "Removing the PEM or PEM Shell" on page 75.
4 Remove the cooling shroud assembly. See "Removing the Cooling Shroud