Dell PowerEdge R905 - Manual (Page 39)

About Your System
39
PCI BIOS failed to
install
PCI device BIOS (Option
ROM) checksum failure
is detected during
shadowing. A cable to an
expansion card is
unseated; an expansion
card is faulty or
improperly installed. Reseat the expansion cards
and expansion card cables.
If the problem persists, see
"Troubleshooting
Expansion Cards" on
page 166.
Plug & Play
Configuration
Error
Error encountered in
initializing PCI device;
faulty system board. Install the NVRAM_CLR
jumper and reboot the
system. See Figure 6-1 for
jumper locations. If the
problem persists, see
"Troubleshooting
Expansion Cards" on
page 166.
Read fault
Requested sector
not found
The operating system
cannot read from the hard
drive, the system could
not find a particular
sector on the disk, or the
requested sector is
defective. Replace the diskette.
Ensure that the diskette
and hard drive cables are
properly connected. See
"Troubleshooting an
Optical Drive" on page 160,
or "Troubleshooting a Hard
Drive" on page 161 for the
appropriate drive(s)
installed in your system.
Remote Access
Controller cable
error or incorrect
card in the RAC
slot.
RAC cables are not
connected, or RAC card is
installed in the wrong
expansion slot. Check that the RAC cables
are connected, and that the
RAC card is installed in the
correct expansion slot. See
"RAC Card" on page 86.
Remote Access
Controller not
installed in the
RAC slot.
RAC card is installed in
the wrong expansion slot. Check that the RAC card is
installed in the correct
expansion slot. See "RAC
Card" on page 86.
Table 1-8. System Messages (continued)
Message Causes Corrective Actions