Removing the riser board – Dell PowerEdge R905 User Manual
Page 84
84
Installing System Components
Figure 3-12.
Riser Boards
Removing the Riser Board
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 67.
3 Remove the PEM. See "Removing the PEM or PEM Shell" on page 75.
4 To remove the riser board, lift both riser retention latches until the riser is
released from its socket, then remove the riser board from the chassis by
lifting up on the retention latches. See Figure 3-13.
1
4-processor riser board
2
2-processor riser board
2
1