Replacing the pem or pem shell – Dell PowerEdge R905 User Manual
Page 78
Advertising
78
Installing System Components
To access the PEM board, remove the cooling shroud. See Figure 3-9.
Figure 3-9.
Removing and Installing the PEM Cooling Shroud
Replacing the PEM or PEM Shell
1 Replace the cooling shroud
2 Rotate the PEM so the PEM board (4-processor systems) or air baffles (2-
processor systems) face downwards.
3 Rotate the PEM handle to the fully open position.
4 Align the three guide pins on each side of the PEM with the corresponding
slots in the sides of the chassis. See Figure 3-7.
1
cooling shroud
2
alignment pins (4)
3
snaps (4)
2
3
1
Advertising