Dimms, Remove and reseat the dimms, Replace the dimms – Dell PowerVault 735N (Rackmount NAS Appliance) User Manual
Page 63: Replace one or more dimms, Expansion cards, Install a correct version of the raid dimm, Replace one or more
Removing and Replacing Parts: Dell PowerVault 735N Systems Service Manual
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/remove.htm[3/15/2013 4:18:18 PM]
2 Expansion card
3 Card guide
4 Expansion-card cage
5 Riser board
6 Expansion-card connector
7 Card-edge connector
Replacing the Expansion Card
To install a replacement expansion card, perform the following steps.
NOTICE: See "
Protecting Against Electrostatic Discharge
" for information on protecting the system from electrostatic discharge.
1. Open the
.
2.
Remove the expansion-card cage
3. Prepare the replacement expansion card for installation.
See the documentation that came with the expansion card for information on configuring the card, making internal connections, or
otherwise customizing the card for the system.
4. Select the expansion slot that you will install the new expansion card in.
5. To release an expansion-card's back-panel bracket, rotate the latch away from the expansion-card bracket (see
).
6. To install the card, insert the card-edge connector firmly into the expansion-card connector on the chassis.
7. When the card is firmly seated in the connector and the card-mounting bracket is aligned with the brackets on either side of it, close the
expansion-card latch.
8. If the expansion card is a full-length card, secure the inner end of the card by closing the plastic latch on the card guide over the top
).
9. Connect any cables that should be attached to the card.
See the documentation that came with the card for information about cable connections.
10.
Install the expansion-card cage into the chassis
.
, and then reconnect the system and peripherals to their AC power sources and turn them on.
DIMMs
The four DIMM sockets on the system board can accommodate 512 MB to 1 GB of registered SDRAM. The DIMM sockets are located near
the back edge of the system board (see
for location on the system board).