Dell PowerVault NX3100 User Manual

Page 50

Advertising
background image

50

Using the System Setup Program and UEFI Boot Manager

Serial Port Address

(Serial Device 1=COM1,

Serial Device 2=COM2

default)

Sets the serial port addresses for the two serial devices.

NOTE:

Only Serial Device 2 can be used for Serial Over

LAN (SOL). To use console redirection by SOL, configure

the same port address for console redirection and the

serial device.

External Serial Connector

(Serial Device1 default)

Specifies whether Serial Device 1, Serial Device 2,

or Remote Access Device has access to the

external serial connector.

NOTE:

Only Serial Device 2 can be used for Serial Over

LAN (SOL). To use console redirection by SOL,

configure the same port address for console redirection

and the serial device.

Failsafe Baud Rate

(115200 default)

Displays the failsafe baud rate used for console

redirection. BIOS attempts to determine the baud rate

automatically. This failsafe baud rate is used only if the

attempt fails. This rate should not be adjusted.

Remote Terminal Type

(VT100/VT220 default)

Sets the remote console terminal type, either

VT100/VT220 or ANSI.

Redirection After Boot

(Enabled default)

Enables or disables BIOS console redirection when the

operating system is loaded.

Option

Description

Advertising