Installing a hard drive into a hard-drive carrier, Internal hard drives, Removing an internal hard drive bay – Dell PowerVault NX3100 User Manual

Page 73: Installing a hard drive into a, Hard-drive carrier

Advertising
background image

Installing System Components

73

Installing a Hard Drive Into a Hard-Drive Carrier

1 Insert the hard drive into the hard-drive carrier with the connector end of

the drive at the back. See Figure 3-7.

2 Align the holes on the hard drive with the holes on the hard drive carrier.

When aligned correctly, the back of the hard drive is flush with the back of

the hard-drive carrier.

3 Attach the four screws to secure the hard drive to the hard-drive carrier.

Internal Hard Drives

Your system supports two cabled 2.5-inch (SAS or SATA) internal hard drives.

Internal hard drives are connected to the SAS backplane. By default, the

operating system is installed on the internal hard drives in a RAID 1

configuration. For information on RAID configuration, see the RAID

documentation on dell.com/support.

Removing an Internal Hard Drive Bay

CAUTION:

Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that
came with the product.

1 Turn off the system and attached peripherals, and disconnect the system

from the electrical outlet and from the peripherals.

2 Open the system. See "Opening the System" on page 66.
3 Lift the latch on your internal hard drive bay and lift it out of the system.

See Figure 3-8.

Advertising