System battery, Replacing the system battery – Dell PowerVault DL2000 User Manual

Page 110

Advertising
background image

110

Installing System Components

See "Running the System Diagnostics" on page 154 for information about
running the diagnostics.

System Battery

The system battery is a 3.0-volt (V), coin-cell battery.

Replacing the System Battery

CAUTION:

Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.

CAUTION:

There is a danger of a new battery exploding if it is incorrectly

installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See your System Information Guide for additional information.

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System" on page 67
3 Locate the battery socket. See "System Board Connectors" on page 158.

NOTICE:

If you pry the battery out of its socket with a blunt object, be careful not to

touch the system board with the object. Ensure that the object is inserted between
the battery and the socket before you attempt to pry out the battery. Otherwise, you
may damage the system board by prying off the socket or by breaking circuit traces
on the system board.

NOTICE:

To avoid damage to the battery connector, you must firmly support the

connector while installing or removing a battery.

4 Remove the system battery.

a

Support the battery connector by pressing down firmly on the positive
side of the connector.

b

While supporting the battery connector, press the battery toward the
positive side of the connector and pry it up out of the securing tabs at
the negative side of the connector.

Book.book Page 110 Monday, September 14, 2009 12:57 PM

Advertising