Dell PowerVault DL2000 - Manual (Page 39)

About Your System
39
PCIe Degraded Link
Width Error:
Embedded
Bus# nn/Dev#nn/Funcn
Expected Link
Width is n
Actual Link Width
is n
Faulty or improperly
installed PCIe card in the
specified slot. Reseat the PCIe card in the
specified slot number. See
"Expansion Cards" on
page 88. If the problem
persists, see "Getting Help"
on page 167.
PCIe Degraded Link
Width Error: Slot n
Expected Link
Width is n
Actual Link Width
is n
Faulty or improperly
installed PCIe card in the
specified slot. Reseat the PCIe card in the
specified slot number. See
"Expansion Cards" on
page 88. If the problem
persists, see "Getting Help"
on page 167.
PCIe Training
Error: Embedded
Bus# nn/Dev#nn/Funcn
PCIe Training
Error: Slot n
Faulty or improperly
installed PCIe card in the
specified slot. Reseat the PCIe card in the
specified slot number. See
"Expansion Cards" on
page 88. If the problem
persists, see "Getting Help"
on page 167.
PCI BIOS failed to
install
PCI device BIOS (Option
ROM) checksum failure is
detected during
shadowing.
Loose cables to expansion
card(s); faulty or
improperly installed
expansion card(s).
Reseat the expansion
card(s). Ensure that all
appropriate cables are
securely connected to the
expansion card(s). If the
problem persists, see
"Troubleshooting Expansion
Cards" on page 149.
Plug & Play
Configuration
Error
Error encountered in
initializing PCI device;
faulty system board. Install the NVRAM_CLR
jumper and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists, see
"Troubleshooting Expansion
Cards" on page 149.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
Book.book Page 39 Monday, September 14, 2009 12:57 PM