Dell PowerVault DL2000 - Manual (Page 35)

About Your System
35
Diskette drive n
seek failure
Incorrect configuration
settings in the System
Setup program. Run the System Setup
program to correct the
settings. See "Using the
System Setup Program" on
page 45.
Faulty or improperly
installed diskette drive. Replace the diskette. If the
problem persists, see
"Troubleshooting an Optical
Drive" on page 143.
Loose tape drive interface
cable, or loose power cable. Reseat tape drive interface
cable, or power cable. If the
problem persists, see
"Troubleshooting an Optical
Drive" on page 143.
Diskette read
failure
Faulty or improperly
inserted diskette or tape
drive. Replace the diskette. See
"Troubleshooting an Optical
Drive" on page 143.
Diskette subsystem
reset failed
Faulty or improperly
installed diskette or tape
drive. Replace the diskette or tape.
If the problem persists, see
"Troubleshooting an Optical
Drive" on page 143.
Drive not ready Diskette missing from or
improperly inserted in
diskette drive. Replace the diskette. If the
problem persists, see
"Troubleshooting an Optical
Drive" on page 143.
Error: Incorrect
memory
configuration.
DIMMs must be
installed in pairs
of matched memory
size, speed, and
technology.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated memory
module(s). Ensure that all pairs of
memory modules are of the
same type and size and that
they are properly installed.
See "System Memory" on
page 100. If the problem
persists, see
"Troubleshooting System
Memory" on page 142.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
Book.book Page 35 Monday, September 14, 2009 12:57 PM