Dell PowerVault DL2000 - Manual (Page 36)

36
About Your System
Error: Memory
failure detected.
Memory size
reduced. Replace
the faulty DIMM as
soon as possible.
Faulty or improperly
seated memory module(s). See "Troubleshooting
System Memory" on
page 142.
!!*** Error: Dell
Remote Access
Controller
initialization
failure*** DRAC
virtual USB
devices may not be
available...
Dell Remote Access
Controller initialization
failure Ensure that the Dell Remote
Access Controller is properly
installed. See "DRAC Card
and Cables" on page 93.
FBD training
error: The
following branch
has been disabled:
Branch x
The specified branch
(channel pair) contains
DIMMs that are
incompatible with each
other. Ensure that only Dell-
qualified memory is used.
Dell recommends
purchasing memory upgrade
kits directly from
www.dell.com or your Dell
sales agent to ensure
compatibility.
Gate A20 failure Faulty keyboard controller;
faulty system board. See "Getting Help" on
page 167.
General failure The operating system is
unable to carry out the
command. This message is usually
followed by specific
information. Note the
information, and take the
appropriate action to resolve
the problem.
Invalid NVRAM
configuration,
Resource Re-
allocated
System detected and
corrected a resource
conflict. No action is required.
Keyboard
Controller failure
Faulty keyboard controller;
faulty system board See "Getting Help" on
page 167.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
Book.book Page 36 Monday, September 14, 2009 12:57 PM