Dell PowerVault DL2000 - Manual (Page 125)

Installing System Components
125
NOTE:
While removing the memory modules, record the memory module socket
locations to ensure proper installation.
10 Remove the heatsink(s) and microprocessor(s). See "Removing a
Processor" on page 105.
11 Remove the TOE key, if present. See Figure 6-2 for the location of the
TOE key.
12 Remove the sideplane. See "Removing the Sideplane Board" on page 116.
13 Remove the SAS backplane. See "Removing the SAS Backplane Board" on
page 118.
14 Remove the system board:
a Pull the system-board tray riser release pin. See Figure 3-28.
b While pulling the release pin, slide the system-board tray toward the
front of the chassis.
c Lift up the system-board tray and remove it from the chassis.
Book.book Page 125 Monday, September 14, 2009 12:57 PM