AVer IWH5000 series - Manual (Page 118)

110
Control Setting of External Device: Set the conditions of the face detection that is trigger by
outside device such as sensor, relay device.
- Activate FaceFinder By External Device: Mark to enable trigger condition.
- Start Message: Set the sensor level that will trigger the face detection. The default is high.
- Stop Message: Set the sensor level that will reset the condition of face detection. The
default is low.
- Reaction Device: Set the activate level of relay device. When the face detects condition
meets the condition in Trigger Condition, the relay will send out the signal and the
system will send out the face object log. The log can be viewed in Face Object Log.
- Trigger Condition: Set the condition for activating relay device to send out the log to DVR
system. Select the time (second) and times (the number of face has been detected) from
drag down list.
- Reset Device Status After: Set the time period to reset activate device back to normal
status. It works only when the activate status is set to trigger.
After set up, click Start Test to test the configure result. When the system is detecting face, the red
frame will show up on the screen. The test result will display in Face log List window as below
figure shown: