AVer IWH5000 series User Manual
Page 198
190
-
In Audio Detection, click the camera number to the system to alarm when detect the
abnormal voice.
5.
In (4) Sensor, select and click on the sensor number (use and to select the sensor) to
set the condition for the system to alarm. If the sensor normal status is high, set the sensor
condition to low.
-
Continue trigger duration: Set a time period that when sensor has been trigger and
stay in the same status for that period, then the alarm will be sent out.
-
Abnormal Event: Enable/disable to set the condition of the event for system to alarm.
System Reboot: when the DVR system reboot without abnormal condition, the
system will send out the alarm message.
Abnormal Reboot: when the DVR system reboot in irregular condition, the system
will send out the alarm message.
Recording is switched off: when the recording has been stopped, the system will
send out the alarm message.
Network is switched off: when the network connection of DVR system is lost, the
system will send out the alarm message.
Hard Disk failed:
when the hard disk can’t work normally, the system will send out
the alarm message.