AVer MOB1304-NET - Manual (Page 26)

20
Chapter 2 Operating the MOB1304 NET
2.1 Using the MOB1304 NET for the First Time
For the first time using the DVR unit, suggest user connect with the LCD monitor and setup DVR
unit by using remote control. Once the DVR unit has been set up, user can operate the DVR unit
through the remote control and LED panel that is located front panel of DVR unit.
Following the below steps for first time setup.
The hard disk drawer must be locked in order for DVR system to detect the hard disk when
DVR system starts up.
The default login ID is ADMIN(case sensitive) and default password is 111111.
1. Make sure all devices and power cables are well connected.
2. Turn on the DVR unit by switching the On/Off switch to ON.
3. User should see the SYSTEM INITIALIZE window appear on the surveillance screen. User
can see the current firmware version of the DVR system. The system will do the self checking
and hard disk detection.
SYSTEM INITIALIZE
FW VERSION B6. 01. 01. 00. 03
SELF CHECK
SUCCESS
HDD STATUS WAIT . . . .
4. When the hard disk has been detected, the STORAGE SETUP windows will appear on the
surveillance screen.
STORAGE SETUP
HDD OVERWRITE
HDD SIZE
953, 849MB
HDD USED 0MB 0%
HDD FORMAT
VIDEO BACKUP
5. For the first time use hard disk, please format the hard disk. Using ¡¡ and ¡¡ to go up
and down and press to make a selection. Select HDD FORMAT and press to
enter HDD format screen.
6. To format the hard disk, the password (default password is 111111) is required. Press
and use ¡¡ and ¡¡ to enter the password. When is done, select EXECUTE and press
to start formatting.