AVer MOB1304-NET - Manual (Page 50)

44
OSD MENU Description
DISPLAY SETUP
COLOR ADJUSTMENT
VIDEO SHIELD
VGA - TV SELECTION
VIDEO OUT SETTING
SPOT MONITOR
EVENT DURATION
AUTO SCAN
CH1
MAIN - MAIN
QUAD
010 SEC
VGA - TV SELECTION
Select the VGA and TV output order.
- MAIN - MAIN: Both VGA and TV output surveillance video on
screen.
- MAIN – SPOT: VGA output surveillance video and TV output
the alarm event video.
- SPOT – MAIN: VGA output alarm event video and TV output
the surveillance video.
SPOT MONITOR
To select the display mode (QUAD or Channel (1, 2, 3, or 4)) on spot
monitor when there is no alarm event.
EVENT DURATION
Set a time gap (10 ~ 999 seconds) before switch back to preview
screen mode after display the alarm event.
AUTO SCAN
Enable/disable auto cycle switch to display the next channel when in
full screen mode.
MAIN MENU
CAMERA/REC
SCHEDULE
EVENT SETUP
DISPLAY
STORAGE
NETWORK
SYSTEM
MISCELLANEOUS
RECORD SCHEDULE
By default, in 24 hours, the recording schedule is set to always record
every hour. Refer to the table below to customize the recording
condition.
Condition Description
ALWAYS Record non-stop.
SMART
Automatically switch to recorded at the frame rate of
FPS(alarm) once an alarm is detected and if there is no
motion, it records at the frame rate of FPS.
The Frame rate setting refers to CHANNEL SETTING.
ALARM
Start recording when the alarm is activated. The alarm
activates status according to the setting in ALARM
SETTING.
CAMERA
Select a channel (1, 2, 3, or 4) or ALL for record schedule setup.
SET TO ALL
Select a recording condition – ALAWAYS, SMART or ALARM.
When each channel has different recording schedule, the time and
date table will display as Green color (VARIED RECORD).
Please refer to the above table for record condition description.