AVer MOB1304-NET - Manual (Page 51)

45
OSD MENU Description
MAIN MENU
CAMERA/REC
SCHEDULE
EVENT SETUP
DISPLAY
STORAGE
NETWORK
SYSTEM
MISCELLANEOUS
EVENT SETUP
Configure alarm, sensor, motion, temperature, shock, and voltage.
EVENT SETUP
ALARM SETTING
SENSOR SETTING
MOTION DETECTION
TEMPERATURE
SHOCK DETECTION
VOLTAGE
ALARM SETTING
Configure parameters of alarm.
ALARM CONTINUOUSLY
ALARM PERIOD
ALARM TYPE
SELECT / DESELECT ALL
SENSOR
RECORD
MOTION DETECTION
TEMPERATURE
VIDEO LOSS
VOLTAGE
SHOCK DETECTION
REMOTE TRIGGER
HDD FAIL
FAN FAIL
005 SEC
ALARM SETUP
1 2 3 4
ALARM TYPE
Select the way of alarming – REC, EMAIL, GSM, BUZZER, or
RELAY.
ALARM PERIOD
Set the amount of time (in seconds) to sending the alarm once
triggered.
ALARM CONTINUOUSLY
Enable/disable the alarm event continuously to display on the spot
monitor until the next alarm event is coming in.
SELECT/DESECLECT ALL
Enable/disable all below selection.
SENSOR
Enable/disable to send out the alarm if sensor has been triggered
according to the setting of SENSOR SETTING.
MOTION DETECTION
Enable/disable to send out the alarm if motion has been detected
according to the setting of MOTION DETECTION.
TEMPERATURE
Enable/disable to send out the alarm when temperature has
exceeded the limit that user has setup.
SHOCK DETECTION
Enable/disable to send out the alarm when MEMS has exceeded the
range that user has setup in SHOCK SETUP.
VOLTAGE
Enable/disable to send out the alarm when 12V VOLTAGE and RTC
DETECTION has been enabled in VOLTAGE SETUP.