AVer MOB1304-NET - Manual (Page 82)

76
(4) Display
- VGA-TV Selection: Select the VGA and TV output order.
 MAIN - MAIN: Both VGA and TV output surveillance video on screen.
 MAIN
– SPOT: VGA output surveillance video and TV output the alarm event video.
 SPOT – MAIN: VGA output alarm event video and TV output the surveillance video.
- SPOT Mode: To select the display mode (QUAD or Channel (1, 2, 3, or 4)) on spot
monitor when there is no alarm event.
- Auto scan: Enable/disable auto cycle switch to display the next channel when in full
screen mode.
- Event Duration: Select the type of event duration.
- Set Duration: Set a time gap (10 ~ 999 seconds) before switch back to preview screen
mode after display the alarm event.
(5) GPS
To enable/disable GPS information message display on surveillance screen.
- LATITUDE
Enable/disable to display latitude information on surveillance screen.
- LONGITUDE
Enable/disable to display longitude information on surveillance screen.
- HEADING
Enable/disable to display heading information on surveillance screen.
- SPEED OVER GROUND
Enable/disable to display speed information on surveillance screen.
- Unit
Select the distance format
– KM(kilometer) or MILE
(6) GSM
To setup the GSM numbers for alarm inform if user has enable GSM alarming function in
ALARM SETUP. Total 5 phone number set can be entered.
- Name
Assign a name for this GSM number such as administrator
‟s phone number.
- Phone
Enter the number will be receive the alarm inform when the alarm event has occurred.