AVer MOB1304-NET User Manual
Page 47
41
OSD MENU
Description
GENERAL SETUP
RECORD MODE
TIME STAMP
DVR NAME
WATERMARK
PRE RECORD
AUTO RECORD
CIF
COMPANY
00 SEC
PRE RECORD
Set the pre-recording time in seconds when alarm has occurred.
CHANNEL SETTING SETUP
120 / 120 FPS
RECORD
ENABLE
AUDIO RECORD
PREVIEW
CH1
CH2
CH3
CH4
MAX. FPS
30
30
30
30
FPS
30
30
30
30
QUALITY
BEST BEST BEST BEST
FPS(ALARM)
30
30
30
30
QUALITY(ALARM)
BEST BEST BEST BEST
ENCRYPTION
CHANNEL SETTING
Configure the parameters of each channel.
ENABLE
Enable/disable the channel to display the video on the surveillance
screen. If the channel is disabling, there won
‟t be any video display
and recording.
RECORD
Enable/disable the channel number to record video.
i
The channels that are enabled in the INSTALLATION can
be set for video recording.
AUDIO RECORD
Enable/disable audio recording. To record sound, make sure the
audio input device (ex: microphone) is connected to the DVR unit.
PREVIEW
Enable/disable the video preview on the surveillance screen.
MAX. FPS
Display the maximum frame rate of recording that user can configure.
Maximum fps total value depends on the RESOLUTION that user has
chosen.
FPS
Set the number of frames per second to be recorded.
The higher the
frame rate, it uses more hard disk space.
QUALITY
Select the video quality setting from BEST, HIGH, GOOD, MEDIUM,
NORMAL or LOW. Choosing higher quality allows user to record less
hours but the quality of the recorded video is better.
FPS(ALARM)
Set the number of frames per second to be recorded when alarm has
occurred.
The higher the frame rate, it uses more hard disk space.
QUALITY(ALARM)
Select the video quality (BEST, HIGH, GOOD, MEDIUM, NORMAL or
LOW) of alarm recording. Choosing higher quality allows user to
record less hours but the quality of the recorded video is better.
CAMERA NAME SETUP
CH3
CH2
CH1
CH4
CAMERA1
CAMERA2
CAMERA3
CAMERA4
CHANNEL NAME
Give a name for the channel 1 ~ 4. Maximum is 12 characters and
may contain A~Z, 0~9, !,
“, #, $, %, &, „, (, ), *, +, -, /, :, ;, <. >, ?, @,
and space.
Current total fps
value that user
has set
Total fps value that
user can set