AVer MOB1304-NET - Manual (Page 57)

51
OSD MENU Description
MAIN MENU
CAMERA/REC
SCHEDULE
EVENT SETUP
DISPLAY
STORAGE
NETWORK
SYSTEM
MISCELLANEOUS
NETWORK SETUP
Setup the network parameters for the internet or intranet remote
monitor or playback.
NETWORK SETUP
VIDEO PORT
IP MODE
UPGRADE PORT
STREAM SETUP
WIRELESS LAN
0080
STATIC
5005
IP MODE
The system provides 3 types of IP setup mode – STATIC, DHCP, and
PPPOE.
- STATIC: Assigns a constant IP address for the DVR system.
- DHCP: Assign the IP address by local DHCP server to DVR
system.
i The DHCP (Dynamic Host Configuration Protocol) is a set
of rules used by a communications device (such as a
computer, router or networking adaptor) to allow the device
to request and get an Internet address from a server which
has a list of addresses available for assignment
- PPPOE: Point-to-Point Protocol over Ethernet is a network
protocol for encapsulating PPP frames in Ethernet frames. It is
used mainly with ADSL services. If your network is using ADSL
service connecting to internet, and then, select PPPOE mode.
VIDEO PORT
A port for the remote connection. Any port can be assigned as a
video port, except the ports already used by the network services.
The default video port is 80.
UPGRADE PORT:
A port for the remote update DVR system firmware. Any port can be
assigned as an upgrade port, except the ports are already used by
the network services. The default upgrade port is 5005. For
Upgrading DVR firmware, please contact your local dealer.
i Please DO NOT cut off the power of the DVR system while
the firmware is upgrading. Power failure will cause the
permanent damage of the DVR system.