AVer MOB1304-NET - Manual (Page 89)

83
- Security: Select the type of encryption
– WEP-64-PSK, WEP-128-PSK, WPA-TKIP-AES.
- Country Code: Then country code is depending on the regulatory region where the AP
device is sold.
i
Please Make sure to enable wireless function first. Please go to OSD menu and select Network >
Wireless LAN. And then, mark Enable check box and select the IP Mode.
(5) WLAN IP Setting
-
ENABLE
Enable/disable the wireless function.
- IP MODE
Select the IP mode of wireless
– STATIC or DHCP.
 STATIC: Assigns a constant IP address for the DVR system.
 DHCP: Assign the IP address by local DHCP server to DVR system.
(6) Stream Setup
Click it to setup each channel stream and quality for the remote site viewing.
(1)
(2)
(3)
(1) Enable
Enable/disable the channel. If channel is disabled, the video stream will not been seen in remote site
and transmitting to remote site.
(2) Network Stream FPS
Set the stream FPS of channel. Scroll the bar to adjust the fps.
(3) Quality
Select the quality of the channel.
(7) 3G Setup
i
- User needs to purchase the 3G USB Dongle in order to make a 3G connection. Please contact your
local dealer for purchasing of 3G USB Dongle.
- Remember to plug 3G USB Dongle into the USB port of the MOB DVR.
Setup parameters of the 3G. The following parameters are provided by
user
‟s 3G service provider when user apply 3G service.
- Dial ON: Enable/disable auto dial function.
- APN: The name used to identify a GPRS bearer service in the
GSM mobile network.
- Number: Enter the number for dialing to your 3G service provider.
- User ID: Enter the ID for accessing authentication.
- Password: Enter the password for accessing authentication.
- Connected NW: The network that you has connected will be
shown after 3G connection is successful.
- IP: The IP address is assigned by your 3G service provider after
3G connection is successful.