AVer MOB1304-NET - Manual (Page 83)

77
8.1.1.2 Camera Setup
(1)
(2)
(3)
(4)
(1) General
- Time Stamp
Enable/disable the time and date display on the each channel.
- Auto Record
Enable/disable auto continue recording when interrupted (i.e., power breakdown, video
playback or configuration setup). It starts to record after 10 second of idleness. This is
applicable in Always Record mode.
- Pre Record
Set the pre-recording time in seconds when alarm has occurred.
- Delay Power-OFF
Set the time for DVR system to power off self after the vehicle has turn off the engine.
(2) Camera
Select the camera and enter a name for the camera.
(3) Color Adjustment
Select the camera and adjust the Brightness, Contrast, Hue and Saturation of the selected
camera. Click Reset to Default Value to set all video setting back to the default.
(4) Audio Setting
Click Reset to Default Value to set all video setting back to the default.
- Audio Out @ Quad
Select the channel to output the audio signal While QUAD mode. Please make sure the
audio output device (such as a speaker) is connected to DVR unit.
- Audio Mute
Enable/disable to hear audio sound while playback. To hear sound, make sure the unit is
connected to a speaker.
i
If you want to hear the voice when you playback the recorded file on this DVR, please make sure that
you have selected Audio Mute Off.
- Volume
To adjust audio output volume.