AVer MOB1304-NET - Manual (Page 86)

80
8.1.1.4 Alarm Setup
(1)
(2)
(3)
(4)
(5)
(6) (7)
(8)
(9)
(1) Alarm Type
Select the way of alarming
– REC, EMAIL, GSM, BUZZER, or RELAY.
(2) Alarm Continuously
Enable/disable the alarm event continuously to display on the spot monitor until the next alarm
event is coming in.
(3) Alarm Period
Set the amount of time(in seconds) to sending the alarm once triggered.
(4) Select/Deselect ALL
To enable/disable all below selection. Click Mail Setup button to setup the alarm mail sending.
- Sensor
Enable/disable to send out the alarm if sensor has been triggered according to the setting
of SENSOR SETTING.
- Motion Detection
Enable/disable to send out the alarm if motion has been detected according to the setting
of MOTION DETECTION.
- Remote Trigger
Allow user to trigger alarm from remote site.
(5) Sensor
Enable/disable initial state of the attached sensor of the channel.
(6) Motion Detection
Enable/disable the channel to detect motion.
(7) Temperature
Click Reset to Default will back to factory default value.
- Temperature Format
Select the temperature pattern display on front LCM panel.
- FAN Control
Enable/disable to setup vale of fan on/off control.
- FAN ON