Figure d-11, Figure d-12 – Digilent 6003-410-000P-KIT User Manual
Page 107
XUP Virtex-II Pro Development System
107
UG069 (v1.0) March 8, 2005
1-800-255-7778
Processor-Based Tests
R
Note the following issues:
a.
For this test, the MAC address of the XUP board is set to: 00:11:22:33:44:55. If your
LAN needs you to register your MAC address to enable access, please contact
your LAN manager to register this MAC address. However, if you use a crossover
cable, this issue does not apply.
b. Input a valid IP address for your LAN environment. If it is fixed based on the
MAC address, contact your LAN manager for the IP address. If you use a
crossover cable, use the default IP address.
c.
By pressing ENTER directly after prompted to input the IP address, the Web server
will use the default IP address as 192.168.0.2. Or you can input your desired IP
address in dot decimal format, and press ENTER when finished.
d. Backspace is not supported currently. So, if you typed the wrong IP address, do
not use backspace. Just press ENTER, and you can correct it later.
e.
After you press ENTER, you will be prompted to verify your IP address. If you
answer “y”, the Web server will be started as shown
. If you answer
“n”, you will repeat step 1.
Figure D-11:
Specifying IP Address for XUP Virtex-II Pro Development System
Figure D-12:
Web Server Running