Figure b-9, Figure b-10 – Digilent 6003-410-000P-KIT User Manual
Page 82
Advertising
82
XUP Virtex-II Pro Development System
1-800-255-7778
UG069 (v1.0) March 8, 2005
Appendix B: Programming the Platform FLASH PROM User Area
R
13. When prompted to compress the file, respond No, because the XUP Virtex-II Pro
Development System hardware does not support this option.
14. After iMPACT successfully creates the MCS file, select Configuration Mode from the
Mode menu as shown in
.
15. Make sure that the XUP Virtex-II Pro Development System is powered up and that
either a USB cable or a PC4 cable connects the board to the PC that is running the
iMPACT software.
16. Select the Initialize Chain command shown in
.
Figure B-9:
Generating the MCS File
Figure B-10:
Switching to Configuration Mode
Advertising