Digilent 6003-410-000P-KIT - Manual (Page 81)

XUP Virtex-II Pro Development System www.xilinx.com 81
UG069 (v1.0) March 8, 2005 1-800-255-7778
R
10. Note that Revision 0 is highlighted in green; this is where the “Golden” configuration
will be placed in the PROM. By selecting your design file for Revision 0, you are just
reserving space in the PROM for the “Golden” configuration. Your design file will not
overwrite the “Golden” configuration because it is write/erase protected.
If the design file was created with the Startup Clock set to JTAG, iMPACT will issue a
warning that the Startup Clock will be changed to CCLK in the bitstream programmed
into the PROM. This warning is shown in
Figure B-7 and can be safely ignored.
11. Once you answer No when prompted to add another design file to Revision 0, the
green revision highlight will move to Revision 1. You will be prompted to add your
design file to Revision 1 as shown in
Figure B-8 .
12. Click on Open and answer No when prompted to add another design file to
Revision 1. Click on Finish to start the generation of the MCS file as shown in
Figure B-9 .
Figure B-7: iMPACT Startup Clock Warning
Figure B-8: Adding the Design File to Revision 1