EVCO EPU2BXP1S1 - Manual (Page 26)

EVCO S.p.A. c-pro 3 micro SAVE/ c-pro 3 kilo SAVE | Application Manual ver. 1.0 | Code 144CP3UKSAE104
EVCO
page 26 of 68
From the main page it is possible to access the state pages by pressing the RIGHT key. Pressing ESC it’s possible to go
to the page for displaying the alarms and log.
4.2.9 State Pages
From the main page it is possible to scroll the free access pages, which show the states of the controlled devices.
These pages are not protected by password and can only be accessed with unit ON. To display them, press the LEFT
and RIGHT keys.
Note: If some devices are disabled from parameter, the information regarding their working
status is replaced with dots “…” in order to avoid filling the state pages with information not
enabled by the control. The same is valid for the disabled probes.
4.2.10 Alarm pages
To display the alarms, select “Show ALARMS>>>” from the general menu or press ESC from the main page to display
this page:
Position the cursor on “Show ALARMS >>” and then press ENTER key.
If no alarms are present the writing “NO ALARS” is displayed. Otherwise every time ENTER key is pushed the next
active alarm is displayed.
For resetting the alarm, in case the alarm condition is expired, keep pushed the ENTER key for about 2 seconds. If the
alarm cause is still active the alarm is not reset and the current mask remains displayed.
If the ESC key is pressed on an alarm page or you wait 60 seconds for timeout, go back to the main page of the
application. This level is not protected by a password.
4.2.11 Log pages
To display the alarms log, select HISTORIAN from the general menu or press ESC from the main page to display this
page:
move the cursor on “Show HISTORIAN >>” and push the ENTER key.
If no elements are present, “NO ALARMS” is displayed otherwise the following page is proposed: