EVCO EPH4DXP1SA - Manual (Page 20)

EVCO S.p.A. c-pro 3 hecto MCSA | User manual ver. 2.0 | Code 144MCSAE204
page 20 of 52
To set/modify the system date and time value, press ENTER on “Orologio (Clock)” and set the desired values, as
shown in the following figure.
3.6 User menu
The user menu is level 0, no password is required to be able to display/modify the parameters present in this branch.
With the purpose of preventing doubts regarding system operation due to excess information not necessary for the
final user, this menu only gives the information useful for the user.
The parameters are set in this menu:
OnOff: Unit status (On/Off)
MOdE: Summer/winter operating mode from keyboard
Set Z.G. (Set D.Z.): Setting the ECO and COM set-points for temperature and humidity in the Zone 1
Set Z.N. (Set N.Z.): Setting the ECO and COM temperature set-point of the Zone 2
Fasce Z.G. (D.Z. period): Setting the Time Periods relative to the Zone 1
Fasce Z.N. (N.Z.period): Setting the Time Periods relative to the Zone 2
Note: The settings relative to the Zone 2 will not be displayed in the User Menu if the zone is disabled (from
parameter).
3.7 Expert Menu
The Expert menu is level 1, i.e. an expert or higher level password must be introduced in order to display/modify the
parameters present in this section.
In the Expert Menu find all status and configuration parameters of the MCSA module that are not given in the User
Menu. Differently to the User Menu, the Expert Menu will also display the status and parameters not enabled.
It is divided into:
States
Maintenance technician
Installer
Manufacturer
Password
3.8 Status Menu
The first page displays the status of the utilities used for system flow line operation