EVCO EPH4DXP1SA - Manual (Page 36)

EVCO S.p.A. c-pro 3 hecto MCSA | User manual ver. 2.0 | Code 144MCSAE204
page 36 of 52
V-Room
Parameters
Contrast
CAN Network
Modbus
Info
Date and real time
The Main menu can also be displayed by operating as follows:
5. Make sure the power supply is connected.
6. Hold the LEFT and ENTER keys for 2 seconds: the display will show the following menu (hereon called Network Status
menu):
Network Status
Loc 99 OK
> >
(go back to
the
Main menu)
1 1 - > >
2 0 - > >
3 0 - > >
4 0 - > >
5 0 - > >
7. Press and release the ENTER key: the display will show the Main menu.
Operate as follows to access a sub-menu:
8. From point 4, press and release the UP or DOWN key to select the sub-menu.
9. Press and release the ENTER key.
Access to the CAN Network sub-menu is protected by a password.
Operate as follows to access the CAN Network:
10. From point 4, press and release the UP or DOWN key to select the CAN Network sub-menu.
11. Press and release the ENTER key.
12. Press and release the ENTER key again.
13. Press and release the DOWN key repeatedly to set “-19”.
14. Press and release the ENTER key.
To modify a configuration parameter belonging to the Parameters sub-menu, the CAN Network sub-menu or the
Modbus sub-menu. operate as follows:
15. From point 9, press and release the UP or DOWN key to select the parameter.
16. Press and release the ENTER key.
17. Press and release the UP or DOWN key to modify the value.
18. Press and release the ENTER key to confirm the value.
19. Press and release the ESC key to go back to the Main menu.