EVCO c-pro kilo AHU - Manual (Page 22)

C-PRO KILO AHU APPLICATION MANUAL
Pag. 22
- : ESC key, identifies current state of machine.
Off: machine on
On: machine off (or machine alarms OFF)
Slow flashing light: machine digital inputs off
Quick flashing light: machine supervisor off
4.2 Page listing
The following paragraph presents the principle pages and menus presented in the application
manual. As previously discussed, the general menu is divided into four sections: User,
Maintenance Operator, Installation Operator, and Constructor. In addition, there is a menu
(with additional open access pages) which can be referenced to operate the system clock.
The structure of the menu is as follows:
⋅
Clock Menu-RTC
⋅
General Menu
⋅
User Menu (Level 1, password for level 1)
⋅
Maintenance Operator Menu (Level 2, password for level 2)
o Maintenance Operator Menu – operating branch
o Maintenance Operaror Menu – manual branch
o Maintenance Operator Menu – input/output branch
⋅
Installation Operator Menu (Level 3, password for level 3)
o Installation Operator Menu – regulation branch
o Installation Operator Menu – fans branch
o Installation Operator Menu – coil branch
o Installation Operator Menu – humidity branch
o Installation Operator Menu – recuperation branch
o Installation Operator Menu – external air shutters branch
o Installation Operator Menu – pumps branch
o Installation Operator Menu – security branch
o Installation Operator Menu – various branch
o Installation Operator Menu – default branch (level 4, only when machine is
off)
⋅
Constructor Menu (Level 4, password for level 4, only when machine is off)
o Constructor Menu – implant branch
o Constructor Menu – hardware IN branch
o Constructor Menu – hardware OUT branch
4.2.1 RTC Menu
This menu contains the functionality of the systems’ RTC:
⋅
setting the clock
⋅
setting the clock during evening hours
⋅
setting the clock offset at Set Point to regulate during evening hours
In order to enter into this menu click ENTER on the RTC mask, accessed from the general
menu.