EVCO c-pro kilo AHU - Manual (Page 29)

C-PRO KILO AHU APPLICATION MANUAL
Pag. 29
4.2.12 History pages
In order to view the alarm history, choose STORICO (HISTORY) from the general Menu.
Alternatively, on the main page you can press the ESC key in order to view the following
page:
Press ENTER on “Mostra STORICO >>”(Show History>>).
If no elements are present you will see “NO ALARMI”(NO ALARMS) written on the screen.
Otherwise, you will arrive at the following page which provides information from the most
recent element memorized in history:
where the information is from the last element reported and memorized in the history. To
view the preceding element press ENTER on “>>”. By repeating this procedure you will be
able to run each element contained in history until you arrive at the first inserted element,
from here, at the request of the successive element, you will view the last memorized
element. The history is viewed in a circular manner.
In order to exit the historical page press the ESC key or wait for the 60 second timeout period
to expire. This level is not password protected.
4.2.13 Project and Firmware Versions
Press down on the UP+DOWN keys simultaneously for approximately two seconds and then
press ENTER on the label InFo. The following information pertaining to the project and
firmware versions of the controller will appear:
To return to the application page press the ESC key.
Historical status
Alarm date and time
Progressive number memorized
Alarm code
Ok: correct reading
Empty: memory empty
Overflow: memory full
Error: historical reading failed
Project: number, version, revision
Controller: mask, version, revision