Futaba CDR-5000 Charger - Manual (Page 13)

14
CDR-5000 Functions
<Setting mode>
ON: If the thermo stand detects the temperature over 40 degrees Celsius, the next cycle of
charging/discharging will be suspended. It restarts as soon as the temperature becomes
below 40 degrees Celsius.
OFF: Regardless with the temperature measured by the sensors, cycle mode will continue. But
the "CUT-OFF TEMPERATURE" remains effective if it has been set at SET-UP.
<Operation key>
Push any one of " ", " ", " " and " " keys to select the mode.
"CYCLE DELAY" is strongly recommended to set "ON" to keep the battery tempera-
ture as low as possible because the battery temperature tends to increase very high
during continuous cycles of charging and discharging under "CYCLE MODE".
WARNING
On the SET-UP screen, you can display confirmation messages or not by setting this parameter. The
default parameter is set to "ON".
<Setting mode>
ON: Display confirmation messages
OFF: Do not display confirmation messages
<Operation key>
Push any one of " ", " ", " " and " " keys to select the mode.
BUZZER
Set the buzzer "ON" or "OFF". The default parameter is set to "ON".
<Setting mode>
ON: It buzzers when the power is turned on, when keys are operated, when charging or dis-
charging is finished.
OFF: No buzzer.
<Operation key>
Push any one of " ", " ", " " and " " keys to select the mode.
TIME
This determines the mode of time display. The default parameter is set to "MS".
<Setting mode>
MS: minute and second (00:00)
S: second (0000S)
<Operation key>
Push any one of " ", " ", " " and " " keys to select the mode.