Futaba CDR-5000 Charger - Manual (Page 27)

28
CDR-5000 Functions
Data Screen
Up to ten of "DATA" screens including the data of charging and discharging can be memorized from the
start and the end of using CDR-5000. Switching off CDR-5000 will clear all the data.
<How to switch "DATA" screen>
"DX DATA" screen and "TX&RX DATA" screen can be obtained by pushing "Data" key.
1. DX DATA screen
[DX DATA --]
DX DATA 01 though 10 represent the data used for DX port. (*DX DATA: The content displayed on
the screen differs from 01 and the others, which are 02 through 10.)
In charge mode, the data in the column of "CHARGE" alone will be shown. And in discharge mode, the
data in the column of "DISCHARGE" alone will be shown. In case of cycle mode, the data of one cycle
in the column of "CHARGE" and "DISCHARGE" will be shown at a time on the same screen. "01"
represents the current cycle. "02" represents the previous cycle. "03" represents the two previous cycle.
And so on. If the cycle mode has been carried out at the latest, the charge and discharge data of the last
cycle will be shown in the "DX DATA 01". And the data of the previous cycle will be shown in the "DX
DATA 02".
<How to operate>
Operate " " and " " keys to get the DATA number.
[Contents of DX DATA01]
MODE
This indicates conditions of a battery for charging or discharging.
NO BAT: No battery is connected.
READY: A battery is connected. Ready to start charging or discharging.
CHG: The battery is now under charging.
D-CHG: The battery is now under discharging.
CYCLE01-99: Cycle charging/discharging is now under operation.