Futaba CDR-5000 Charger - Manual (Page 24)

25
CDR-5000 Functions
5. Cycle Charging/Discharging
[Cycle Charging/Discharging at DX]
1)Push "DX CYCLE" key.
2)Either the blue LED of "DX Discharging" or the red LED of "DX Charging" turns on. MODE
indicator changes from "READY" to "CYCLE01". And charging or discharging will start.
*The cycle starts with the mode that is preset by the "FIRST CYCLE" in the "INITIAL SETTING". (D-CHG: start from
discharging, CHG: start from charging)
3)When the starting mode is over, "FINISHED---" screen is shown and the next mode starts.
When the cycle mode is over, "FINISHED---" screen will be shown again. (One cycle means a
discharge and a charge or a charge and a discharge.)
*If the "CYCLE DELAY" is set to "ON" in the "INITIAL SETTING", the next charging/discharging mode will not be carried out
as long as the Thermo Stand reads the temperature higher than 40 degrees Celsius. However, the next charging/discharging mode
will restart again if the temperature goes down below 40 degrees Celsius.
4)If the cycle time is set at 2 times or more, the MODE indication will change from "CYCLE 2" to
"CYCLE 3" and so on after the first one cycle.
5)As soon as the Cycle Charging/Discharging is over, "FINISHED---" screen of either Charge or
Discharge will be shown. Those screens are exactly same as those shown in the single Charge
and Discharge modes.
<How to return to "DX DATA" screen>
Push "Data" key to return to "DX DATA" screen from "FINISHED---" screen.
[Cycle Charging/Discharging at TX/RX]
1)Push "TX/RX CYCLE" key.
2)Either the blue LED of "TX/RX Discharging" or the red LED of "TX&RX Charging" turns on.
MODE indicator changes from "READY" to "CYCLE01". And charging or discharging will start.
*The cycle starts with the mode that is preset by the "FIRST CYCLE" in the "INITIAL SETTING". (D-CHG: start from
discharging, CHG: start from charging)
3)When the starting mode is over, "FINISHED---" screen is shown and the next mode starts.
When the cycle mode is over, "FINISHED---" screen will be shown again. (One cycle means a
discharge and a charge or a charge and a discharge.)
*The "CYCLE DELAY" that is defined in the "INITIAL SETTING" is not applicable at TX/RX.
4)If the cycle time is set at 2 times or more, the MODE indication will change from "CYCLE 2" to
"CYCLE 3" and so on after the first one cycle.
5)As soon as the Cycle Charging/Discharging is over, "FINISHED---" screen of either Charge or
Discharge will be shown. Those screens are exactly same as those shown in the single Charge
and Discharge modes.
<How to return to "TX&RX DATA" screen>
Push "Data" key to move to "DX DATA" screen from "FINISHED---" screen, then push "Data" key
again to return to "TX&RX DATA" screen.