Futaba CDR-5000 Charger - Manual (Page 22)

23
CDR-5000 Functions
[End of discharging at DX]
Alarm buzzer will beep as soon as discharging at DX is over. And "FINISHED DX DISCHARGE"
screen will be shown. The blue LED of "DX Discharging" is turned off. Discharging process is now
completed.
*If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
<How to return to "DX DATA" screen>
Push "Data" key to return to "DX DATA"
screen from "FINISHED DX DISCHARGE"
screen.
CUTOFF BY
This shows the item that is detected at first among the items related to DISCHARGE CUT in the "SET-
UP" screen.
*VOLT: When the voltage level was used for DISCHARGE CUT.
*TIMER: When timer was used for DISCHARGE CUT.
POWER LEVEL
This is the number that represents the status of a battery under discharging by calculating from the
voltage drop of the battery to which a certain constant load is applied. The bigger the number is, the
better the condition of the battery is. Take into consideration this number as a guide for daily mainte-
nance of batteries. The maximum is 120%.
FINISHING BATTERY TEMP.
This shows the temperature of a battery when the discharging of the battery is completed.