Cdr-5000 functions – Futaba CDR-5000 Charger User Manual
Page 41
42
CDR-5000 Functions
"DISCHARGE AMPERE IS TOO HIGH!"
This message appears when a discharging current is set at between 10A and 40A for "SET DIS-
CHARGE" at DX in the "SET-UP" screen. Please confirm if there is no problem with the value before
moving on to next procedure. This message will appear no more than two times.
*If the warning is set to "OFF" in the Initial-setting, this warning will not be displayed.
"CUT-OFF DELTA VOLTAGE IS TOO HIGH!"
This message appears when a Delta Peak Detection Voltage is set at between 20mV/cell and 50mV/cell
for "C CUT-OFF DELTA VOLT" at DX in the "SET-UP" screen. Please confirm if there is no problem
with the value before moving on to next procedure. This message will appear no more than two times.
*If the warning is set to "OFF" in the Initial-setting, this warning will not be displayed.
"CUT-OFF TEMPERATURE IS TOO HIGH!"
This message appears when a battery temperature to stop charging is set at between 50 and 75 degrees
Celsius for "C CUT-OFF TEMPERATURE" at DX in the "SET-UP" screen. Please confirm if there is
no problem with the value before moving on to next procedure. This message will appear no more than
two times.
*If the warning is set to "OFF" in the Initial-setting, this warning will not be displayed.
"CUT-OFF MAX. VOLT IS TOO HIGH!"
This message appears when the maximum battery voltage is set at over 13V for "C CUT-OFF MAX
VOLT" at DX in the "SET-UP" screen. Please confirm if there is no problem with the value before
moving on to next procedure. This message will appear no more than two times.
*If the warning is set to "OFF" in the Initial-setting, this warning will not be displayed.
"CUT-OFF CAPACITY IS TOO HIGH!"
This message appears when a charging capacity is set at over 4000mAh for "C CUT-OFF CAPACITY"
at DX in the "SET-UP" screen. Please confirm if there is no problem with the value before moving on to
next procedure. This message will appear no more than two times.
*If the warning is set to "OFF" in the Initial-setting, this warning will not be displayed.
"CHECK YOUR CEELS NUMBER!" or "TOO MANY CELLS!"
This message appears when the number of battery cells is changed for "CELL NUMBER" at DX in the
"SET-UP" screen. Please confirm if there is no problem with the value before moving on to next
procedure. This message will appear no more than two times.
*If the warning is set to "OFF" in the Initial-setting, this warning will not be displayed.