YSI 6200 User Manual
Page 13
YSI 6200 DAS USER Manual
YSI/Massachusetts 508.748.0366, Fax 508.748.2543
Page 2-4
Assuming that all shipping cartons have been opened and the equipment has been initially
checked for damage, proceed by doing the following.
1.
Place the 6200 Data Collection Platform enclosure on a work surface, leaving space for
accessories to be laid out and connected. Position the enclosure so that the bottom (connector
ports) faces toward you. Next open the hinged cover, by releasing the two latches on the right
side. Refer to the diagram below, and remember that the diagram may differ slightly from your
unit based on the components you ordered.
Met Suite
Rain Gauge
Pyranometer
Antenna or RF cable port
Barometer Vent
Conduit Fittings for AC,
solar, and phone lines
6-Series Sonde
bottom view of enclosure
Front Cover
Grounding Terminal
AC Power In
Radio or
Cell Modem
Phone Modem
Battery
Digital I/O
Analog Inputs
Phone
Solar Power In
Fuse
COM Port
Desiccant Pack
Barometer
Figure 2.2 6200 Data Collection Platform, Component and Connector Layout
2.
If a radio is installed in the 6200 DCP enclosure, you should locate the field antenna that you
ordered and connect it to the antenna connector on the bottom of the enclosure.
CAUTION!
To avoid permanent damage to the radio transceiver, connect the antenna before
powering the 6200 DCP or the radio base unit.