YSI 6200 User Manual
Page 27
YSI 6200 DAS USER Manual
YSI/Massachusetts 508.748.0366, Fax 508.748.2543 Page 2-18
Click on OK to exit the menu and return to the main EcoWatch DCP menu screen. A window
appears momentarily, displaying the message Programming 6200...Please Wait. When
EcoWatch DCP is done downloading the new configuration it will reboot the 6200 DCP. You
should hear a long beep from the 6200 DCP as it starts up again.
Once the main menu appears, click on 6200 to pull down the menu and click on Interrogate
Now. Any data that has been collected by the DCP will appear. If readings do not appear
initially, you will need to wait as much time as the sample interval you chose above. A
countdown timer in the lower right corner of the window will give you the time to next
interrogation.
Below you see readings that have been uploaded to EcoWatch DCP from the 6200 DCP. Up to
seven lines of data may be displayed at one time, the bottom line being the most current. Note
that there are three separate display “sheets”. Simply click on the sheet label near the bottom of
each window to view readings from YSI SDI-12 Sonde 0, MET Sensors, or Internal Sensors.
You can not display all sensor readings in one window simultaneously.