YSI 6200 - Manual (Page 41)

YSI 6200 DAS USER Manual
YSI Massachusetts 508.748.0366, Fax 508.748.2543 Page 4-4
4.3 Installing the Battery
This section describes the procedure for powering a 6200 DCP that will operate in the field on
battery power only. As described in Section 2, the battery is shipped in a separate carton and
therefore must be installed into the 6200 DCP enclosure. No tools are required to install the
battery.
CAUTION!
Before installing the battery read all instructions and safety information included with the
battery including any safety labels attached to the battery or its carton.
CAUTION!
If you have a unit with a 2-way radio, connect the antenna to the RF connector on the
bottom of the enclosure before powering the 6200 DCP. This will avoid possible
permanent damage to the radio transceiver.
Slide the battery into the open area (shown in Figure 4.2). The battery leads should be visible
from a grommet in the interface plate. Connect the red lead to the positive terminal by sliding
the tab connector over the battery tab. Connect the blue lead to the negative terminal in the same
way. Your 6200 DCP is now powered. It will beep for about 5 seconds during boot up.
Battery
Compartment
Desiccant Pack
+
-
CONNECT ANTENNA CABLE TO RF
CONNECTOR IF RADIO INSTALLED.
Battery
Battery
Digital I/O Analog Inputs
Phone
Solar Power In
+
-
COM Port
Antenna cable
Figure 4.2 Installing the Battery