Jwinding – SINGER 1500 Izek User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Place a spool of thread on the spool pin, and secure it with the spool pin cap (small). Pull the
thread out from the spool through thread guides (1) and (2).
2. Pull end of thread through hole in
bobbin as shown.
3. Push bobbin winder shaft to far left
position, if it is not already there. Place
bobbin onto shaft with end of thread
coming from top of bobbin. Push bobbin
winder shaft to the right until it clicks. Hold
onto end of thread.
completely filled. Push shaft to the left
to remove bobbin and cut thread.