Fte-8tfirt to continue! 5eming, Fldd to ffloorites, Error message during setting-up – SINGER 1500 Izek User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The sewing machine will stop
automatically if “UNIT OF PATTERN"
was selected at the screen 8 (page
42).
If "SERIES OF PATTERN” was
selected, stop the machine at the
desired position.
ftE-8TfiRT TO CONTINUE!
5EMING
13
► MODFY-
flDD TO FflOORITES
mm.
ja
Push A Button to return to
screen 8. (page 42).
“ADD TO FAVORITES",
see page 45.
Push A Button to return to
screen 2 (page 42).
■ Push the (^) Control Pad
to select “E".
Push the A Button
Error message during setting-up
CHECK FLfiSHING
flREfl AND START
SEHING MACHINE
If the sewing machine is not set up correctly, the above message
will be displayed when starting the machine.
1. Push A Button.
2. The error message will be displayed. Fix the problem following
the instructions in the message. (Refer to page 67.)
3. When the error has been cleared, screen 11 (page 43) will be
displayed.
4. Start the machine.
*The start/stop switch on the sewing machine will flash red for 2 -
3 seconds and will then change to green. However, the sewing
machine will not start again until the cause of the error has been
properly cleared, even if you try to start the machine, so make
sure that you clear the cause of the error properly.
44