Choosing and changing needles, Changing the needle plate (a), (c), Changing screw-on presser feet (h) – SINGER 7025 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
choosing and changing
needles
• Raise needle to its highest position,
• Loosen needle clamp screw and remove
needle.
• With flat side of needle to the back, insert
new needle up into clamp as far as it will go.
• Tighten needle clamp screw securely.
Changing the needle
plate (A), (C)
• Raise needle and presser foot.
• Open slide plate.
• Lift up needle plate from right corner and
slide out from under foot.
• To replace needle plate, slide it under pin
('ll and push it firmly to the left.
• Press down until it snaps into place.
Changing screw-on
presser feet (H)
• Raise needle and presser foot.
• Loosen presser foot screw (1) and remove
presser foot with shank (2), guiding it toward
you and to the right.
• To replace presser foot with shank, hook
shank around the presser bar and tighten
presser foot screw with the use of a coin.
14