Winding a bobbin – SINGER 7025 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Winding a bobbin

Winding a bobbin is quick and easy when you foilow the directions beiow. Aiways wind the bobbin

before threading the machine and needle.

• Push in indent (1) on hand wheel disc. This wiii stop the needie from moving.

• Place spool of thread on spool pin.

• Slide spool cap (2) firmly over rim of spool to prevent thread tangling.

• Lead thread from spool and snap into thread guide post (3).

• Wind thread clockwise around front of bobbin winder tension disc (4).

• Pass thread end, from inside, through small hole in rim of bobbin.

• Place bobbin on spindle and push it to the right.

• Holding thread end, step on speed controller to run machine until desired amount of thread

is wound. (Winding stops automatically once bobbin is full).

• Cut thread; push bobbin to the left and remove it from spindle.

• Trim thread end from top of bobbin.

• Return hand wheel disc to sewing position by pressing on side opposite indent.


This manual is related to the following products: