SINGER 216G User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Bobbin Case (Fig. 15, 16, 17)
Hold the bobbin, which
has been
fully wound with
----------------- ,
thread, in the right
‘
/ j hand so that the thread
I''
i
from left
to right (Fig. 15). With
the left hand, grasp the
bobbin
case
and
place
the
bobbin into it
(Fig. 15).
Fig. 15
Then pull the thread with the
right hand through the slot in
the edge of the bobbin case j
(Fig. 16) and further to the left ,
Fig. 16
under
the
tension
spring.
Let
the
end
of
the
thread
hang
down, next to the position finger
of the bobbin case, as shown
Fig. 17
in Fig. 17.
I
To Replace the Bobbin Case
After threading, hold the bobbin case by the latch
between the thumb and forefinger of the left hand, and
replace it on the center stud of the shuttle body, so
that the position finger (F, Fig. 12) fits into the notch
of the shuttle race. The bobbin case must be pressed
20